Bearing - GEG 100 ES SKF

20x47x14 mm

Single-row deep groove ball bearing 16204 FAG in an open design for high speeds, low friction and radial plus axial loads in both directions. Suitable for compact arrangements with a 20 mm shaft diameter.

30x62x20 mm

NU 2206 BNA P62 ZKL single-row cylindrical roller bearing is designed for high radial loads and allows axial displacement of the shaft relative to the housing in both directions. P62 denotes P6 dimensional and running accuracy combined with reduced C2 radial internal clearance.

25x33x20 mm

NK 25/20 INA needle roller bearing without an inner ring provides high radial load capacity within a very small cross-section. The needles run directly on a suitably hardened and ground 25 mm shaft raceway.

Insert bearing YAR 206 2F SKF is designed for bearing units and is secured to the shaft by two set screws in the extended inner ring. This arrangement provides quick and reliable mounting.

A contact seal and flinger on both sides help protect the bearing from contaminants. The design is suitable for both constant and alternating directions of rotation.

50x90x20 mm
Rubber seals on both sides

Single-row deep-groove ball bearing 6210 2RSR ZVL for radial load and moderate axial loads in both directions. Contact rubber seals on both sides retain lubricant and protect the rolling elements from dust, contaminants and splashing moisture.

20x47x14 mm
Higher accuracy class P4

High-precision spindle ball bearing S 6204 C TA P4 GMN for precision arrangements carrying combined radial load and axial load in one direction. The complete C TA P4 design, pairing and required preload must be preserved when replacing it.

30x72x27 mm

Double-row angular contact ball bearing 3306 CX for combined radial and axial loads in both directions. This stocked item is specified with a width of 27 mm; compare it carefully with the original bearing before replacement.

14x22x20 mm

Needle roller bearing without inner ring NK 14/20-XL INA for high radial loads in a compact space. The 14 mm dimension is the under-roller diameter, not a conventional bore; a suitably prepared shaft surface forms the inner raceway.

Insert bearing UC 204 ZKL is designed for matching bearing housings and units. Its extended inner ring is secured to the shaft by two set screws, enabling quick mounting.

The spherical outside surface facilitates alignment in the housing seat, while seals on both sides help protect the bearing interior from common contaminants.

Cylindrical roller bearing NU 306 ZKL is a single-row radial bearing with high load capacity. The NU design has two integral flanges on the outer ring and an inner ring without flanges.

It permits axial displacement of the shaft relative to the housing in both directions and is therefore primarily used as a non-locating bearing. It does not provide axial shaft location.