Bearing - NN 3014 TN SP SKF

65x120x24.75 mm

Single-row tapered roller bearing 30213 A P6X ZVL for combined radial load and axial load in one direction. The P6X precision version is intended for arrangements with higher dimensional and running-accuracy requirements; the complete A P6X designation must match the machine documentation.

Deep groove ball bearing 6205 2Z ZVL is a single-row bearing with non-contact metal shields on both sides. It accommodates radial loads and moderate axial loads in both directions.

The 2Z design helps retain lubricant and limits the ingress of common contaminants while maintaining low friction. The shields are not watertight and are not intended for direct exposure to liquids.

NA 4906 V DKF needle roller bearing is a full-complement radial bearing with machined outer and inner rings. The high number of needles provides high radial load capacity in a small radial cross-section; the design is intended for carefully lubricated arrangements at moderate speeds.

14x22x20 mm

Needle roller bearing without inner ring NK 14/20-XL INA for high radial loads in a compact space. The 14 mm dimension is the under-roller diameter, not a conventional bore; a suitably prepared shaft surface forms the inner raceway.

60x150x35 mm

Single-row deep-groove ball bearing 6412 N ZKL for radial and axial loads in both directions. The N design has a snap-ring groove in the outer ring; when replacing, retain the complete designation and verify the axial locating method.

Needle roller bearing HK 2012 CX is a thin-walled bearing with a drawn outer cup, cage and needle rollers. Its open-ended design without an inner ring provides high radial load capacity within a very small radial space.

The raceway is normally formed by a hardened and ground shaft surface; when the shaft cannot meet the raceway requirements, a suitable separate inner ring must be used.

61904 2RS EZO deep-groove ball bearing is a single-row bearing with contact rubber seals on both sides. It carries radial loads and moderate axial loads in both directions, while the factory grease is protected against leakage and common contaminants.

6014 2RSR FAG deep-groove ball bearing is a single-row bearing with RSR contact seals on both sides. It carries radial loads and moderate axial loads in both directions while protecting the factory grease against leakage, dust and moisture.

Four-point contact ball bearing Q 305 P63 DKF is a single-row angular contact bearing for axial loads in both directions. It provides bidirectional axial shaft location within a compact cross-section.

The P63 suffix combines P6 accuracy and C3 axial internal clearance. This version must match the application requirements and is not an automatic substitute for Normal accuracy or clearance.

SS 61800 2Z neu stainless deep-groove ball bearing is a thin-section single-row bearing with non-contact metal shields on both sides. It combines low friction and protection of the factory lubricant against common dust, while the stainless design offers better corrosion resistance than conventional bearing steel.