Bearing - NU 217 ECML C3HVA305 SKF

50x80x20 mm

Single-row tapered roller bearing 32010 X FAG with a separable design for high combined radial and one-direction axial loads. Compare the exact X variant with the original part; this product designation does not include XL.

40x80x23 mm

Single-row cylindrical roller bearing NU 2208 E DPI for high radial loads. The NU design allows axial displacement of the shaft relative to the housing in both directions; E denotes an increased-capacity internal design.

35x72x23 mm

NJ 2207 ZKL single-row cylindrical roller bearing is designed for high radial loads and can also locate the shaft axially in one direction. Its separable construction allows the inner ring to be installed independently of the outer ring and roller assembly.

30x62x16 mm

NUP 206 E ZVL single-row cylindrical roller bearing carries high radial loads and locates the shaft axially in both directions through its flange arrangement. The E suffix denotes an optimized internal design with increased load capacity.

17x47x14 mm

Single-row deep groove ball bearing 6303 Z SRO with a non-contact metal shield on one side. A versatile design for radial loads and light axial loads in both directions, offering low friction and good speed capability.

35x72x17 mm

Single-row cylindrical roller bearing N 207 ZKL for high radial loads and accurate shaft guidance. The N design permits axial displacement of the shaft relative to the housing in both directions; when replacing, compare the complete designation and required internal clearance.

35x72x17 mm

Single-row deep-groove ball bearing 6207 N ZKL for radial and axial loads in both directions. The N design has a snap-ring groove in the outer ring; when replacing, retain the complete designation and verify the axial locating method.

30x62x20 mm

NU 2206 BNA P62 ZKL single-row cylindrical roller bearing is designed for high radial loads and allows axial displacement of the shaft relative to the housing in both directions. P62 denotes P6 dimensional and running accuracy combined with reduced C2 radial internal clearance.

40x68x19 mm

Single-row tapered roller bearing 32008 JR DPI for high radial loads combined with axial load in one direction. Its separable design simplifies mounting and allows running clearance or preload to be set in a paired arrangement.

35x72x42.9 mm

Radial insert ball bearing GYE 35 KRR B INA with a spherical outside surface, extended inner ring and locking by grub screws. Seals on both sides protect the rolling contact; the bearing is designed for installation in a matching bearing housing.

35x72x42.9 mm

UC 207 DPI insert ball bearing with an extended inner ring is secured to the shaft by two grub screws. Its spherical outer surface is designed for installation in a matching bearing housing.