Bearings, Page 3

30x55x17 mm

32006 JR DPI is a single-row tapered roller bearing for arrangements exposed to radial load together with axial load in one direction. Its separable design allows the inner ring assembly with cage and rollers to be mounted independently of the outer ring.

It is suitable for gearboxes, hubs, shafts and other precise industrial arrangements. Tapered roller bearings are normally used in opposed pairs when axial forces must be supported in both directions.

30x72x19 mm

6306 2Z TIMKEN is a single-row deep-groove ball bearing with two non-contact metal shields. Its versatile design supports radial load and moderate axial loads in both directions, while low friction makes it suitable for higher speeds.

The shields help retain lubricant and limit the entry of larger contaminants. This is a general-purpose machine bearing, not a contact-sealed or watertight design.

30 × 62 × 23.8 mm

3206 C2 ZKL double-row angular contact ball bearing in an open design with reduced C2 internal clearance for combined loading.

30x72x19 mm

6306 2RS ZVL deep-groove ball bearing is a single-row radial bearing with rubber seals on both sides. It carries radial loads and moderate axial forces in either direction. The 2RS design helps protect the internal rolling contact from dust and moisture while retaining lubricant inside the bearing.

NA 4906 V DKF needle roller bearing is a full-complement radial bearing with machined outer and inner rings. The high number of needles provides high radial load capacity in a small radial cross-section; the design is intended for carefully lubricated arrangements at moderate speeds.

Insert bearing YAR 206 2F SKF is designed for bearing units and is secured to the shaft by two set screws in the extended inner ring. This arrangement provides quick and reliable mounting.

A contact seal and flinger on both sides help protect the bearing from contaminants. The design is suitable for both constant and alternating directions of rotation.

Deep groove ball bearing 6006 2Z C3 ZVL is a single-row bearing with metal shields on both sides and C3 radial internal clearance. It accommodates radial loads and moderate axial loads in both directions.

The non-contact 2Z shields limit contaminant ingress while maintaining low friction. C3 clearance is greater than Normal and must suit the temperature, speed and fit; it is not an automatic substitute for standard clearance.

Self-aligning ball bearing 2306 E 2RS1TN9 SKF has two rows of balls and a common spherical raceway in the outer ring. This design accommodates static and dynamic misalignment between the shaft and housing.

Seals on both sides help protect the bearing interior from contaminants. It is suitable for arrangements where shaft deflection or mounting misalignment can occur.

Cylindrical roller bearing NU 306 ZKL is a single-row radial bearing with high load capacity. The NU design has two integral flanges on the outer ring and an inner ring without flanges.

It permits axial displacement of the shaft relative to the housing in both directions and is therefore primarily used as a non-locating bearing. It does not provide axial shaft location.

30x72x19 mm

Single-row cylindrical roller bearing NJ 306 FRB for high radial loads and axial location in one direction. The NJ design permits axial displacement of the shaft relative to the housing in the opposite direction; when replacing, compare the complete designation and required internal clearance.

30x72x27 mm

Double-row angular contact ball bearing 3306 CX for combined radial and axial loads in both directions. This stocked item is specified with a width of 27 mm; compare it carefully with the original bearing before replacement.

30x62x16 mm

NUP 206 E ZVL single-row cylindrical roller bearing carries high radial loads and locates the shaft axially in both directions through its flange arrangement. The E suffix denotes an optimized internal design with increased load capacity.