Bearings, Page 3
Product sorting
List of products
7204 AA ZKL single-row angular-contact ball bearing is designed for combined radial and axial loads. Under the ZKL designation system, the AA execution has a 26° contact angle and carries axial load in one direction.
Insert bearing UC 204 ZKL is designed for matching bearing housings and units. Its extended inner ring is secured to the shaft by two set screws, enabling quick mounting.
The spherical outside surface facilitates alignment in the housing seat, while seals on both sides help protect the bearing interior from common contaminants.
20x47x14 mm
Higher accuracy class P4
High-precision spindle ball bearing S 6204 C TA P4 GMN for precision arrangements carrying combined radial load and axial load in one direction. The complete C TA P4 design, pairing and required preload must be preserved when replacing it.
17x47x14 mm
Single-row deep groove ball bearing 6303 Z SRO with a non-contact metal shield on one side. A versatile design for radial loads and light axial loads in both directions, offering low friction and good speed capability.
30x47x11 mm
ZKL 51106 N thrust ball bearing is designed to carry axial load in one direction. It is used where force acting along the shaft axis must be reliably supported.
Rubber seals on both sides
20x47x14 mm
CT 1204 MGK self-aligning ball bearing with two rows of balls compensates minor shaft-to-housing misalignment. The MGK suffix is part of the full designation, which should always be compared when selecting a bearing.
Metal shields on both sides
20x47x14 mm
ZKL 1204 self-aligning ball bearing with two rows of balls compensates minor shaft-to-housing misalignment. It is intended mainly for radial loads and limited axial loads in both directions. The K suffix is part of the full designation, which should always be compared when selecting a bearing.
Injection moulded cage of glass fibre reinforced polyamide 66
20x47x18 mm
SKF bearing with the complete designation 4204 ATN9 SKF. When selecting a replacement, compare the full designation, dimensions and design required for the application.
20x47x14 mm
Metal shields on both sides
KINEX ball bearing for industrial use. Before ordering, compare the complete designation, dimensions, design and application requirements with the manufacturer documentation.
30x47x17 mm
Rubber seals on both sides
CX needle roller bearing with sealing on both sides for compact radial arrangements. Verify designation, dimensions and application requirements before selection.