Bearings 12 × 28 × 8 mm

Bearing - 6001 2RS ZVL

12 × 28 × 8 mm. Single-row deep-groove ball bearing with contact rubber seals on both sides (2RS). Check the complete designation and application suitability.

Bearing - 6001 2RS KINEX

12 × 28 × 8 mm. Single-row deep-groove ball bearing. Rubber seals on both sides; compare the complete designation before ordering.

Bearing - 6001 2RS SKF

12 × 28 × 8 mm. single-row deep groove ball bearing with contact rubber seals on both sides. A compact solution for radial and moderate axial loads in both directions, protected against dust, contamination and lubricant loss.

Bearing - 6001 2Z SKF

12 × 28 × 8 mm. single-row deep groove ball bearing with non-contact metal shields on both sides. It combines low friction and lubricant retention with the ability to carry radial and moderate axial loads in both directions.

Bearing - 6001 Z ZKL

12 × 28 × 8 mm. Metal shield on one side. ZKL single-row deep groove ball bearing for compact rotating assemblies.

Bearing - 6001 URB

12 × 28 × 8 mm. single-row open deep groove ball bearing for radial and axial loads in both directions. Dynamic load rating 5.1 kN, mass 0.022 kg.

Bearing - 6001 ZKL

12 × 28 × 8 mm. Single-row deep groove ball bearing for common radial and moderate axial loads. Its versatile open design provides low friction, smooth running and straightforward relubrication.

Bearing - S 6001 2RS neu

12 × 28 × 8 mm. deep-groove ball bearing is a single-row bearing with contact rubber seals on both sides. It carries radial loads and moderate axial loads in both directions, while the factory grease is protected against leakage and common contaminants.

Bearing - SS 6001 2RS CRB

12 × 28 × 8 mm. Deep groove ball bearing is a compact single-row 6001-series bearing with rubber seals on both sides. It is suitable for shaft arrangements carrying radial and moderate axial loads. The double-sealed design helps protect the bearing interior from common contaminants. Before ordering, compare the complete designation, dimensions and operating requirements; the SS prefix is part of this….