Bearing - 6404 SKF

HK 3520 CX drawn-cup needle roller bearing is an open-ended, thin-walled bearing without an inner ring. It provides high radial load capacity in a very small radial space; a suitably hardened and precision-ground shaft forms the inner raceway.

2302 2RS CODEX self-aligning ball bearing has two rows of balls and a spherical raceway in the outer ring, allowing it to compensate for angular misalignment between the shaft and housing. Rubber seals on both sides protect the factory grease and the bearing interior against common contaminants.

50x90x20 mm

The 6210 N KINEX deep-groove ball bearing is a single-row radial bearing with a snap-ring groove in the outer ring. The groove simplifies axial location in the housing, while the deep raceways support radial loads and moderate axial forces in both directions.

This open, unsealed design is suitable for gearboxes, electric motors and industrial positions with a separate lubrication system.

YAR 207 2F SKF insert bearing has an inner ring extended on both sides and locks onto the shaft with two set screws. A spherical outside surface, contact seals with flingers on both sides and relubrication capability support easy installation and reliable operation.

61904 2RS EZO deep-groove ball bearing is a single-row bearing with contact rubber seals on both sides. It carries radial loads and moderate axial loads in both directions, while the factory grease is protected against leakage and common contaminants.

55x63x25 mm

The HK 5525 ZEN drawn-cup needle roller bearing is a thin-walled, open-ended bearing without an inner ring. It provides high radial load capacity where radial installation space is very limited.

The shaft acts directly as the inner raceway and therefore requires suitable hardness, accuracy and surface finish. This bearing does not provide axial location.

Cylindrical roller bearing NU 2210 ZKL is a single-row radial bearing with high load capacity. The NU design has two integral flanges on the outer ring and an inner ring without flanges.

It permits axial displacement of the shaft relative to the housing in both directions and is therefore primarily used as a non-locating bearing. It does not provide axial shaft location.

25x42x20 mm

The GE 25 E 2RS ZVL radial spherical plain bearing has spherical sliding surfaces and rubber seals on both sides. It accommodates oscillating movement and misalignment while supporting high radial and combined loads.

Suitable for hydraulic cylinders, linkages, articulated mechanisms, agricultural and construction machinery. Its steel sliding surfaces require appropriate lubrication.

SS 61800 2Z neu stainless deep-groove ball bearing is a thin-section single-row bearing with non-contact metal shields on both sides. It combines low friction and protection of the factory lubricant against common dust, while the stainless design offers better corrosion resistance than conventional bearing steel.