Bearing - NU 210 ECML C3HS1 SKF

35x72x17 mm

Single-row deep-groove ball bearing 6207 N ZKL for radial and axial loads in both directions. The N design has a snap-ring groove in the outer ring; when replacing, retain the complete designation and verify the axial locating method.

45x85x23 mm

Double-row self-aligning ball bearing 2209 E2RS1TN9 SKF with contact seals on both sides and a polyamide cage. It accommodates slight misalignment and shaft deflection and carries radial loads together with light axial loads in both directions.

50x80x20 mm

Single-row tapered roller bearing 32010 JR DPI for high radial load combined with axial load in one direction. Its separable design allows the inner ring with rollers and the outer ring to be mounted independently.

35x72x17 mm

Double-row self-aligning ball bearing 1207 K ZKL with a 1:12 tapered bore. It accommodates slight misalignment and shaft deflection while carrying radial loads and light axial loads in both directions.

35x100x25 mm

Single-row cylindrical roller bearing NJ 407 ZKL for high radial loads with axial shaft location in one direction. The NJ design permits axial displacement in the opposite direction; when replacing, compare the complete designation and required internal clearance.

20x47x14 mm
Higher accuracy class P4

High-precision spindle ball bearing S 6204 C TA P4 GMN for precision arrangements carrying combined radial load and axial load in one direction. The complete C TA P4 design, pairing and required preload must be preserved when replacing it.

30x62x16 mm

NUP 206 E ZVL single-row cylindrical roller bearing carries high radial loads and locates the shaft axially in both directions through its flange arrangement. The E suffix denotes an optimized internal design with increased load capacity.

10x26x8 mm

6000 2RSH C3 SKF deep groove ball bearing has contact rubber seals on both sides and greater-than-normal C3 radial internal clearance. The seals protect lubricant and raceways, while C3 provides allowance for clearance reduction caused by fits or operating temperature.

45x75x20 mm

Single-row tapered roller bearing 32009 AX ZKL for high radial load combined with axial load in one direction. Its separable design allows the inner ring with rollers and the outer ring to be mounted independently.

25x33x20 mm

NK 25/20 INA needle roller bearing without an inner ring provides high radial load capacity within a very small cross-section. The needles run directly on a suitably hardened and ground 25 mm shaft raceway.