Bearings, Page 2

10x30x9 mm

6200 2RS ZVL is a single-row deep-groove ball bearing with contact rubber seals on both sides. It supports radial and limited axial loads while protecting the lubricant and raceways in commonly contaminated operation.

10x30x14 mm

Double-row self-aligning ball bearing 2200 E-2RS1TN9 SKF with seals on both sides. It accommodates static and dynamic misalignment and supports reliable operation in compact bearing arrangements.

10x26x8 mm

6000 Z C6 ZKL is a single-row deep-groove ball bearing with one non-contact metal shield; the opposite side remains open. The design supports radial load and moderate axial loads in both directions while maintaining low friction.

The shield helps retain lubricant and limits the entry of larger contaminants from one side. C6 is part of the complete designation and must be checked against the original bearing or ZKL documentation when selecting a replacement.

10x30x9 mm

6200 2Z DPI is a single-row deep-groove ball bearing with two non-contact metal shields. It supports radial load and moderate axial loads in both directions, while its low-friction design makes it suitable for higher speeds.

The shields help retain lubricant and limit the entry of larger contaminants. This is a general-purpose machine bearing, not a contact-sealed or watertight design.

10x35x11 mm

6300 ZKL is an open, single-row deep-groove ball bearing. It supports radial load and moderate axial loads in both directions, while its low-friction design makes it suitable for higher speeds.

The open design has no shields or seals, allowing easy lubricant access and effective heat dissipation. It therefore requires a clean arrangement with suitable lubrication or external sealing.

SS 61800 2Z neu stainless deep-groove ball bearing is a thin-section single-row bearing with non-contact metal shields on both sides. It combines low friction and protection of the factory lubricant against common dust, while the stainless design offers better corrosion resistance than conventional bearing steel.

6000 2RS1 SKF deep-groove ball bearing is a single-row bearing with rubber seals on both sides. It carries radial loads and moderate axial loads in both directions while protecting the factory grease against leakage and common contaminants.

10x26x8 mm

6000 2RSH C3 SKF deep groove ball bearing has contact rubber seals on both sides and greater-than-normal C3 radial internal clearance. The seals protect lubricant and raceways, while C3 provides allowance for clearance reduction caused by fits or operating temperature.

Dimensions: 10 × 30 × 9 mm
Deep groove ball bearing, shielded on both sides (2Z).

10x24x9 mm
STEYR 51100 thrust ball bearing is designed to carry axial load in one direction. It is used where force acting along the shaft axis must be reliably supported.

10x26x8 mm
Deep groove ball bearing, shielded on both sides (2Z).

10x30x9 mm
SKF bearing with the complete designation 6200 Z SKF. When selecting a replacement, compare the full designation, dimensions and design required for the application.

10x24x9 mm
ZVL 51100 thrust ball bearing is designed to carry axial load in one direction. It is used where force acting along the shaft axis must be reliably supported.