Bearings, Page 34

Bearing - NJ 2207 ZKL

35 × 72 × 23 mm. single-row cylindrical roller bearing is designed for high radial loads and can also locate the shaft axially in one direction. Its separable construction allows the inner ring to be installed independently of the outer ring and roller assembly.

Bearing - LM300811/LM300849 TIMKEN

40.988 × 67.975 × 17.501 mm. single-row tapered roller bearing set consists of the LM300849 inner cone and the LM300811 outer cup. This imperial-series design carries radial load together with axial load in one direction.

Bearing - 6408 ZVL

40 × 100 × 25 mm. Rolling bearing for use in machinery and equipment.

Bearing - 6307 2RSR KINEX

35 × 80 × 21 mm. single-row deep groove ball bearing with contact rubber seals on both sides. A dependable choice for radial and bidirectional axial loads where retaining lubricant and protecting the bearing interior from contamination are important.

Bearing - 6000 2RSH C3 SKF

10 × 26 × 8 mm. deep groove ball bearing has contact rubber seals on both sides and greater-than-normal C3 radial internal clearance. The seals protect lubricant and raceways, while C3 provides allowance for clearance reduction caused by fits or operating temperature.

Bearing - 1306 MGM

30 × 72 × 19 mm. MGM bearing for industrial applications. When replacing a part, always verify the complete designation, dimensions, design and application requirements against the manufacturer documentation.

Bearing - 1209 ETN9 SKF

45 × 85 × 19 mm. SKF bearing for industrial applications. When replacing a part, always verify the complete designation, dimensions, design and application requirements against the manufacturer documentation.

Bearing - NU 2208 E DPI

40 × 80 × 23 mm. Single-row cylindrical roller bearing for high radial loads. The NU design allows axial displacement of the shaft relative to the housing in both directions; E denotes an increased-capacity internal design.

Bearing - 6205 NR SKF

25 × 52 × 15 mm. Technické provedení a kompatibilitu ověřte podle úplného označení výrobce a požadavků aplikace.

Bearing - 3205 B TVH FAG

25 × 52 × 20 mm. Technické provedení a kompatibilitu ověřte podle úplného označení výrobce a požadavků aplikace.

Bearing - 30210 A FAG

50 × 90 × 21.75 mm. Technické provedení a kompatibilitu ověřte podle úplného označení výrobce a požadavků aplikace.

Bearing - 1305 HARP

25 × 62 × 17 mm. HARP bearing for industrial applications. When replacing a part, always verify the complete designation, dimensions, design and application requirements against the manufacturer documentation.

Bearing - 51203 P6 ZKL

17 × 35 × 12 mm. thrust ball bearing is designed to carry axial load in one direction. It is used where force acting along the shaft axis must be reliably supported.