DPI

8x24x8 mm

Open single-row 628 deep-groove ball bearing for accurate support of small shafts and rotating mechanisms. It carries radial load and limited axial load in both directions.

20x52x16.25 mm
DPI 30304 single-row tapered roller bearing for combined radial and axial loads. The separable cone with rollers and outer-ring cup simplify mounting and precise clearance or preload adjustment.

40x80x18 mm
DPI 6208 single-row deep-groove ball bearing for reliable radial-load support together with limited axial loads in both directions.

30x55x17 mm

32006 JR DPI is a single-row tapered roller bearing for arrangements exposed to radial load together with axial load in one direction. Its separable design allows the inner ring assembly with cage and rollers to be mounted independently of the outer ring.

It is suitable for gearboxes, hubs, shafts and other precise industrial arrangements. Tapered roller bearings are normally used in opposed pairs when axial forces must be supported in both directions.

25x52x15 mm

6205 2RS DPI is a single-row deep-groove ball bearing with contact seals on both sides. The seals help retain lubricant and protect the rolling space from dust, moisture and other common contaminants.

Its versatile design supports radial load and moderate axial loads in both directions. It is well suited to applications where dependable bearing protection and low maintenance requirements are important.

10x30x9 mm

6200 2Z DPI is a single-row deep-groove ball bearing with two non-contact metal shields. It supports radial load and moderate axial loads in both directions, while its low-friction design makes it suitable for higher speeds.

The shields help retain lubricant and limit the entry of larger contaminants. This is a general-purpose machine bearing, not a contact-sealed or watertight design.

15x28x7 mm

6902 2RS DPI thin-section deep-groove ball bearing with rubber seals on both sides for compact arrangements and protection of the lubricant from contamination.

15x35x14 mm

62202 2RS DPI deep-groove ball bearing is a single-row radial bearing with rubber seals on both sides. It carries radial loads and moderate axial forces in either direction. The 2RS design helps protect the internal rolling contact from dust and moisture while retaining lubricant inside the bearing.

40x68x19 mm

Single-row tapered roller bearing 32008 JR DPI for high radial loads combined with axial load in one direction. Its separable design simplifies mounting and allows running clearance or preload to be set in a paired arrangement.

50x80x20 mm

Single-row tapered roller bearing 32010 JR DPI for high radial load combined with axial load in one direction. Its separable design allows the inner ring with rollers and the outer ring to be mounted independently.

40x80x23 mm

Single-row cylindrical roller bearing NU 2208 E DPI for high radial loads. The NU design allows axial displacement of the shaft relative to the housing in both directions; E denotes an increased-capacity internal design.