15 × 35 × 11 mm. single-row deep-groove ball bearing with rubber seals on both sides. A versatile design for radial and limited axial loads in both directions, protected against common contaminants. Also compare the additional P66 designation when selecting a replacement.
30 × 55 × 13 mm. Open single-row deep groove ball bearing. It primarily carries radial load and also limited axial loads in both directions; the open design provides direct access for lubrication and requires protection from the surrounding arrangement.
17 × 40 × 12 mm. bearing with the verified designation. Compare the complete designation, dimensional data and design with the original part. Confirm suitability for the specific bearing arrangement in DKF documentation.
8 × 24 × 8 mm. Open single-row 628 deep-groove ball bearing for accurate support of small shafts and rotating mechanisms. It carries radial load and limited axial load in both directions.
25 × 47 × 12 mm. single-row deep-groove ball bearing with rubber seals on both sides. A versatile design for radial and limited axial loads in both directions, protected against common contaminants.
17 × 35 × 10 mm. single-row deep-groove ball bearing with rubber seals on both sides. A versatile design for radial and limited axial loads in both directions, protected against common contaminants.
6 × 19 × 6 mm. is a single-row deep-groove ball bearing with two non-contact metal shields. Its versatile design supports radial load and moderate axial loads in both directions, while low friction makes it suitable for higher speeds. The shields help retain lubricant and limit the entry of larger contaminants. This is a general-purpose machine bearing, not a contact-sealed or watertight design.
10 × 30 × 9 mm. is a single-row deep-groove ball bearing with two non-contact metal shields. It supports radial load and moderate axial loads in both directions, while its low-friction design makes it suitable for higher speeds. The shields help retain lubricant and limit the entry of larger contaminants. This is a general-purpose machine bearing, not a contact-sealed or watertight design.
10 × 26 × 8 mm. single-row deep-groove ball bearing with non-contact metal shields on both sides. A low-friction shielded design for radial and limited axial loads in both directions.
8 × 22 × 7 mm. single-row deep-groove ball bearing with non-contact metal shields on both sides. A low-friction shielded design for radial and limited axial loads in both directions. The C3 suffix denotes greater-than-normal radial internal clearance.
40 × 60 × 13 mm. thrust ball bearing is designed to carry axial load in one direction. It is used where force acting along the shaft axis must be reliably supported.
