Bearings 40 × 80 × 18 mm

Bearing - 6208 2RSR FAG

40 × 80 × 18 mm. Single-row deep-groove ball bearing. Rubber seals on both sides; compare the complete designation before ordering.

Bearing - 6208 2Z ZKL

40 × 80 × 18 mm. Metal shields on both sides single-row deep-groove ball bearing with a steel cage and non-contact shielding. Low friction and shields on both sides help retain the lubricant inside the bearing.

Bearing - 6208 2RS1 SKF

40 × 80 × 18 mm. SKF bearing for industrial applications. When replacing a part, always verify the complete designation, dimensions, design and application requirements against the manufacturer documentation.

Bearing - 6208 DPI

40 × 80 × 18 mm. single-row deep-groove ball bearing for reliable radial-load support together with limited axial loads in both directions.

Bearing - 6208 2RS ZKL

40 × 80 × 18 mm. deep-groove ball bearing is a single-row radial bearing with rubber seals on both sides. It carries radial loads and moderate axial forces in either direction. The 2RS design helps protect the internal rolling contact from dust and moisture while retaining lubricant inside the bearing.

Bearing - 6208 2Z INA

40 × 80 × 18 mm. deep-groove ball bearing is a single-row radial bearing with non-contact metal shields on both sides. It supports radial loading and moderate axial forces in either direction. The 2Z shields help retain lubricant and keep out coarse contaminants while maintaining low friction and suitability for higher speeds.

Bearing - 6208 2Z ROLLWAY

40 × 80 × 18 mm. Metal shields on both sides. Single-row deep-groove ball bearing for radial load and moderate axial loads in both directions. Non-contact metal shields retain grease with low friction and protect against ordinary dry contamination.

Bearing - 6208 N ZKL

40 × 80 × 18 mm. Single-row deep groove ball bearing in open design, with a snap-ring groove in the outer ring. Suitable for radial and axial loads in both directions; the N suffix denotes the groove, not an included snap ring.

Bearing - 6208 2RS1 C3 SKF

40 × 80 × 18 mm. Rubber seals on both sides. Greater radial internal clearance.

Bearing - 6208 2RS KINEX

40 × 80 × 18 mm. KINEX bearing for industrial applications. When replacing a part, always verify the complete designation, dimensions, design and application requirements against the manufacturer documentation.

Bearing - NJ 208 E ZVL

40 × 80 × 18 mm. Technické provedení a kompatibilitu ověřte podle úplného označení výrobce a požadavků aplikace.

Bearing - NJ 208 FRB

40 × 80 × 18 mm. Technické provedení a kompatibilitu ověřte podle úplného označení výrobce a požadavků aplikace.

Bearing - N 208 E TGP P52 STEYR

40 × 80 × 18 mm. Technické provedení a kompatibilitu ověřte podle úplného označení výrobce a požadavků aplikace.