Bearings, Page 2

Single-row 32008 AX KINEX tapered roller bearing is a separable single-row bearing for high radial loads combined with axial load in one direction. Two bearings in an opposed arrangement are normally used when axial location is required in both directions.

32208 FBJ tapered roller bearing is a separable single-row bearing for high radial loads combined with axial load in one direction. Two bearings in an opposed arrangement are normally used when axial location is required in both directions.

6008 2RS ZVL deep-groove ball bearing is a single-row bearing with rubber seals on both sides. It carries radial loads and moderate axial loads in both directions while protecting the factory grease against leakage and common contaminants.

40x68x19 mm

Single-row tapered roller bearing 32008 JR DPI for high radial loads combined with axial load in one direction. Its separable design simplifies mounting and allows running clearance or preload to be set in a paired arrangement.

40x62x22 mm

Single-row cylindrical roller bearing NU 4908 DKF for high radial loads and free axial displacement of the shaft relative to the housing in both directions. The NU design has two guiding flanges on the outer ring and a flange-free inner ring.

40x90x23 mm
Metal shields on both sides
Greater radial internal clearance

Single-row deep-groove ball bearing 6308 2Z C3 SKF for radial load and axial loads in both directions. Two non-contact metal shields retain lubricant with low friction; C3 clearance provides allowance for tight fits or elevated operating temperature.

40x80x18 mm
Metal shields on both sides

Single-row deep-groove ball bearing 6208 2Z ROLLWAY for radial load and moderate axial loads in both directions. Non-contact metal shields retain grease with low friction and protect against ordinary dry contamination.

40x80x18 mm

Single-row deep groove ball bearing 6208 N ZKL in open design, with a snap-ring groove in the outer ring. Suitable for radial and axial loads in both directions; the N suffix denotes the groove, not an included snap ring.

40x90x34 mm

Double-row angular contact ball bearing 3308 D DKF for combined radial and axial loads in both directions. Its rigid, non-separable design provides accurate shaft guidance and can also accommodate tilting moments.

40x80x23 mm

Single-row cylindrical roller bearing NU 2208 E DPI for high radial loads. The NU design allows axial displacement of the shaft relative to the housing in both directions; E denotes an increased-capacity internal design.

40x80x18 mm
Single-row ball bearing 6208 2RS KINEX with rubber seals on both sides.