Bearing - NN 3010 KTN UP SKF

35x80x21 mm

6307 Z ZKL deep groove ball bearing has a non-contact metal shield on one side. The shield limits the ingress of larger contaminants and lubricant loss while retaining low friction; the opposite side remains open.

20x47x14 mm
Higher accuracy class P4

High-precision spindle ball bearing S 6204 C TA P4 GMN for precision arrangements carrying combined radial load and axial load in one direction. The complete C TA P4 design, pairing and required preload must be preserved when replacing it.

40x80x18 mm

Single-row deep groove ball bearing 6208 N ZKL in open design, with a snap-ring groove in the outer ring. Suitable for radial and axial loads in both directions; the N suffix denotes the groove, not an included snap ring.

35x72x17 mm

Single-row cylindrical roller bearing N 207 ZKL for high radial loads and accurate shaft guidance. The N design permits axial displacement of the shaft relative to the housing in both directions; when replacing, compare the complete designation and required internal clearance.

35x72x42.9 mm

UC 207 DPI insert ball bearing with an extended inner ring is secured to the shaft by two grub screws. Its spherical outer surface is designed for installation in a matching bearing housing.

35x53.6x12.8 mm

Special single-direction thrust ball bearing 511Z35 ZKL for axial load in one direction. Separable design with a shaft washer, housing washer and ball-and-cage assembly; compare the full designation and dimensions before replacement.

40x90x23 mm
Metal shields on both sides
Greater radial internal clearance

Single-row deep-groove ball bearing 6308 2Z C3 SKF for radial load and axial loads in both directions. Two non-contact metal shields retain lubricant with low friction; C3 clearance provides allowance for tight fits or elevated operating temperature.

17x26x5 mm
Rubber seals on both sides

Thin-section ball bearing 61803 2RS MTM for compact arrangements carrying radial and axial loads in both directions. Rubber seals on both sides protect the grease from dust and moisture; when replacing, retain the complete 2RS designation.

28x58x16 mm

Single-row deep-groove ball bearing 62/28 FBJ JAPAN with a special 28 mm bore for radial and axial loads in both directions. The open design allows lubrication to be selected for the application; when replacing, compare the complete designation, dimensions and required clearance.

25x62x17 mm

1305 HARP double-row self-aligning ball bearing with a cylindrical bore can accommodate slight misalignment between the shaft and housing. The open design is suitable for radial loads and limited axial loads in both directions.

35x55x20 mm

NA 4907 DKF needle roller bearing with machined rings and its own inner ring provides high radial load capacity within a small radial section. It is suitable where the shaft surface cannot be used directly as a precision raceway.