Bearing - 2317 KM SKF

Insert bearing YAR 206 2F SKF is designed for bearing units and is secured to the shaft by two set screws in the extended inner ring. This arrangement provides quick and reliable mounting.

A contact seal and flinger on both sides help protect the bearing from contaminants. The design is suitable for both constant and alternating directions of rotation.

Cylindrical roller bearing NU 2210 ZKL is a single-row radial bearing with high load capacity. The NU design has two integral flanges on the outer ring and an inner ring without flanges.

It permits axial displacement of the shaft relative to the housing in both directions and is therefore primarily used as a non-locating bearing. It does not provide axial shaft location.

Deep groove ball bearing SS 6001 2RS CRB is a compact single-row 6001-series bearing with rubber seals on both sides. It is suitable for shaft arrangements carrying radial and moderate axial loads.

The double-sealed design helps protect the bearing interior from common contaminants. Before ordering, compare the complete designation, dimensions and operating requirements; the SS prefix is part of this specific variant designation.

95x170x45.5 mm

Single-row tapered roller bearing 32219 E ZKL for high radial loads and axial load in one direction. The separable design simplifies mounting; the E suffix is part of the exact designation and must match the equipment documentation when replacing the bearing.

12x28x11 mm

Single-direction thrust ball bearing 51201 URB for carrying axial load in one direction. Its separable design simplifies installation of the individual washers and ball-and-cage assembly; when replacing, compare the complete designation, dimensions and load direction.

Four-point contact ball bearing Q 305 P63 DKF is a single-row angular contact bearing for axial loads in both directions. It provides bidirectional axial shaft location within a compact cross-section.

The P63 suffix combines P6 accuracy and C3 axial internal clearance. This version must match the application requirements and is not an automatic substitute for Normal accuracy or clearance.

35x72x42.9 mm

Radial insert ball bearing GYE 35 KRR B INA with a spherical outside surface, extended inner ring and locking by grub screws. Seals on both sides protect the rolling contact; the bearing is designed for installation in a matching bearing housing.

50x90x21.75 mm

Single-row tapered roller bearing 30210 A P6X ZVL for high radial loads and axial load in one direction. The P6X tolerance version is intended for arrangements with higher accuracy requirements; the complete A P6X designation must match when replacing the bearing.

100x215x73 mm

Spherical roller bearing 22320 KM ZKL with a tapered bore and machined brass cage for high radial loads and axial loads in both directions. Its self-aligning design helps accommodate misalignment and shaft deflection.

20x47x14 mm

Single-row deep groove ball bearing 16204 FAG in an open design for high speeds, low friction and radial plus axial loads in both directions. Suitable for compact arrangements with a 20 mm shaft diameter.

45x85x30 mm

Double-row angular contact ball bearing 3209 ZKL for combined radial loads and axial loads in both directions. A robust solution for arrangements requiring good rigidity and accurate shaft guidance.