Bearing - NJ 2320 ECMA SKF

HK 1210 B INA drawn-cup needle roller bearing is an open-ended, thin-walled bearing without an inner ring. It provides high radial load capacity in a very small radial space; a suitably hardened and precision-ground shaft forms the inner raceway.

Deep groove ball bearing SS 6001 2RS CRB is a compact single-row 6001-series bearing with rubber seals on both sides. It is suitable for shaft arrangements carrying radial and moderate axial loads.

The double-sealed design helps protect the bearing interior from common contaminants. Before ordering, compare the complete designation, dimensions and operating requirements; the SS prefix is part of this specific variant designation.

62209 2RS KINEX deep-groove ball bearing is a single-row bearing with rubber seals on both sides. It carries radial loads and moderate axial loads in both directions while protecting the factory grease against leakage and common contaminants.

61904 2RS EZO deep-groove ball bearing is a single-row bearing with contact rubber seals on both sides. It carries radial loads and moderate axial loads in both directions, while the factory grease is protected against leakage and common contaminants.

NA 4906 V DKF needle roller bearing is a full-complement radial bearing with machined outer and inner rings. The high number of needles provides high radial load capacity in a small radial cross-section; the design is intended for carefully lubricated arrangements at moderate speeds.

90x160x40 mm

Spherical roller bearing 22218 CCKW33 SKF with a tapered bore and W33 relubrication features. It carries high radial loads and axial loads in both directions, while its self-aligning design accommodates misalignment.

20x47x14 mm
Higher accuracy class P4

High-precision spindle ball bearing S 6204 C TA P4 GMN for precision arrangements carrying combined radial load and axial load in one direction. The complete C TA P4 design, pairing and required preload must be preserved when replacing it.

65x120x32.75 mm

Single-row tapered roller bearing 32213 ZKL for high radial loads and axial load in one direction. The separable outer ring simplifies installation; the correct clearance or preload is set in conjunction with an opposing bearing.

28x58x16 mm

Single-row deep-groove ball bearing 62/28 FBJ JAPAN with a special 28 mm bore for radial and axial loads in both directions. The open design allows lubrication to be selected for the application; when replacing, compare the complete designation, dimensions and required clearance.